VIDEO
Laboratory testing of end products
Laboratory testing of end products
Laboratory testing of woven material
Laboratory testing of woven material
Laboratory testing of slings
Laboratory testing of slings
Assemble your big bag
Forward a request Certificates

The main objective of PLASTCON, LLC (Russia) in the area of quality is to produce and sell competitive high-quality products both on domestic and international markets, which products shall satisfy known and anticipated demands of the Customers and also highest international quality standards.

 

In the light of the defined objective, the Quality Service is addressing the following main tasks:

  • Developing proposals as to the formulation and implementation of quality policy;
  • Drawing-up the quality system documents;
  • Exercising leadership in the areas of general quality management, product testing and quality control and also products certification and quality systems.

 

The Quality Service of PLASTCON, LLC consists of Process Service and Testing & Control Laboratory.

Listed below are the priority tasks of the enterprise’s Process Service: ensuring the required level of pre-production engineering; developing and maintaining process and design documentation for the produced articles; searching for means to enhance production and labour efficiency; implementing measures aimed at the product quality improvement; developing technical proposals and technical assignments for new articles; carrying out technical supervision over the introduction of new processes and products.

 

The activity of the Testing & Control Laboratory is directed at the control of raw materials, intermediate and end products in accordance with regulatory documents, at the development of methods for control of the raw materials, intermediate and end products’ quality (including workplace and in-situ control), acquisition of information on the products quality and state of production, and also development and implementation of measures to prevent rejections.

The Testing & Control Laboratory of PLASTCON, LLC is fitted with advanced equipment of both domestic and European producers. All of the laboratory instruments are subject to annual check in the Federal Government Institution «Center for Testing and Certification — St. Petersburg».

 

The strength properties of intermediate products (polypropylene tape yarns, polypropylene fabric and tape materials) are measured with the use of universal tensile machines produced in Great Britain.

 

The test stand (made in Great Britain) with a safe working load of 100 kH used in the factory makes it possible to perform tensile strength testing of any kinds of the flexible containers produced (i.e. to perform measurement of the product’s strength reserve) and also stability cyclic testing.


Entry inspection of raw materials (measurement of polypropylene melt flow index).
Entry inspection of raw materials (measurement of polypropylene melt flow index)
Measurement of the polypropylene fabric’s tensile strength and elongation.
Measurement of the polypropylene fabric’s tensile strength and elongation
Measurement of the polypropylene sling’s strength properties.
Measurement of the polypropylene sling’s strength properties